• Home
  • About company
    • Certification
  • Representative
    • ZEZ SILKO
    • SEMICONDUCTORS
  • Controllers (PFC) KMB
    • NOVAR 1005 - 1007
    • NOVAR 1106 - 1114
    • NOVAR 1206 - 1214
    • NOVAR 1312
    • NOVAR 2100
    • NOVAR 2200
    • NOVAR 2400
    • NOVAR 2600
    • NOVAR 2700
    • KATKA 12 ST
    • KATKA 20 D
    • KATKA 20 ST
    • KATKA 20 T
    • KATKA 80 D
    • KATKA 80 T/ST
  • Thyristors, Diodes
    • THYRISTORS
    • DIODES
    • MODULES
    • IGBT
  • Download
  • Contacts

ProductsBGENGRUS

Power capacitors 
Low voltage power capacitors
Medium voltage power capacitors
Capacitors type CPEFS 23 - three phase
Capacitors type CUEFS 23 - single phase
Capacitors type CUFFS 23 - single, live
Controllers (PFC) KMB System 
Induction heating capacitors 
Induction heating up to 1 000 kVAr,6 kHz
Induction heating up to 2 000 kVAr,4 kHz
Induction heating up to 2 500 kVAr,4 kHz
Induction heating up to 8 000 kVAr,8 kHz
Induction heating up to 5 000 kVAr,5 kHz
Induction heating up to 6 000 kVAr,4 kHz
Induction heating up to 70 kHz, COAX
Induction heating up to 200 kHz MIDICOAX
Induction heating up to 5 000 kVAr, 120 kHz
Induction heating up to 6 000 kVAr, 10 kHz
Capacitors for power electronics 
DC link (filtering) capacitors
AC filter capacitors
Snubber capacitors for IGBT
Snubber capacitors for SCR and GTO
HV capacitors for general purposes
Ripple control coupling capacitors
Surge capacitors (medium voltage)
Commutating capacitors
Energy storage (impuls) capacitors 
Capacitor banks 
Components for PFC 
Contactors for capacitors
Reactors
High voltage transformers
Thyristors, Diodes, Modules, IGBT 

Medium voltage power capacitors

For more details please open our catalogue

Capacitors type CPEFS 23 - three phase
Capacitors type CUEFS 23 - single phase
Capacitors type CUFFS 23 - single, live

Application

The capacitors are designed for power factor correction and harmonics filtration at medium voltage. They are all-film dielectric – polypropylene foil impregnated with an environmentally friendly, non-toxic biodegradable insulating oil. There is the aluminium foil as the electrodes. This construction assures minimal looses of the capacitors. Three-phase units are in star – Y connection, single-phase units are in I connection. The capacitors have internal discharge resistors.

Installation instruction
  • Impregnant is free from PCB and is completely non-toxic. It is very stable over a wide operating temperature range
  • All three-phase and single-phase units are in dead case
  • Single-phase units are available with two bushings or connected with a single bushing and live case
  • Low voltage pressure sensor 230 V, 50 Hz available
  • Terminal cover IP42 available
  • Stainless steel case, paint finish. For indoor/outdoor installation
  • Max torque – hollow studs M12 - 10 Nm
  • Max torque - earth connection M10 - 7 Nm
Technical data
Rated voltage:   UN   Three-phase 1-24 kV 25 … 1000 kvar
Single-phase 1-15 kV 25 … 1000 kvar
Frequency:   fN   50/60 Hz
Standards:       IEC 60871-1: 1997 EN 60871-1: 1997 EN ČSN 60871-1; 1999
IEC 60871-4: 1997 EN 60871-4: 1997 EN ČSN 60871-4; 1999
Max overvoltage:   Umax  

UN + 10 % (up to 8 hours daily)
UN + 15 % (up to 30 minutes daily)
UN + 20 % (up to 5 minutes)
UN + 30 % (up to 1 minute)

Overcurrent (according to above standards):   IS   1,3 * IN
Capacitance tolerance:       -5 / +10 %
Test voltage, terminal/terminal:   UTT   2,15 * UN, AC, 10 s or 4,3 * UN DC, 10 s
Test voltage, terminal / case:   UTC   According to relevant IEC standard for 10 s
Inrush current:       Max 300 x IN
Dielectric losses:   tan δ   cca 0,07 W/kvar
Statistical life expectancy:       > 130 000 hours
Degree of protection:       IP 00, on request IP 42, indoor and outdoor
Ambient temperature category:       -50 °C / C  - maximum is 50 °C (higher temp. on request)
                 - highest mean over any period of 24 h is 40 °C
                 - highest mean over any period of 1 year is 30 °C
Cooling:       naturally air cooled
Permissible relative humidity:       IP00-max. 95 %, IP42-max. 95 %
Max above sea level:       4 000 m above sea level
Mounting position:       vertical
Mounting:       Side brackets, bottom brackets
Case:       Stainless-steel, for indoor/outdoor installation
Dielectric:       All-film
Impregnant:       JARYLEC (environmentally friendly, non toxic, non PCB)
Discharge resistors:       Included -  75 V, 10 minute

 

 

Insulating level
Insulating level

[kV]
Max. operating
network voltage
Um [kV]
Creepage
distance
[mm]
   
20/60
28/75
38/95
50/125
70/170
7,2
12
17,5
24
36
140
203
318
457
635
three-phase
three-phase
three-phase

 
single-phase
single-phase
single-phase
single-phase
single-phase

 

Technical details

Installation instruction
  • Impregnant is free from PCB and is completely non-toxic. It is very stable over a wide operating temperature range
  • All three-phase and single-phase units are in dead case
  • Single-phase units are available with two bushings or connected with a single bushing and live case
  • Low voltage pressure sensor 230 V, 50 Hz available
  • Terminal cover IP42 available
  • Stainless steel case, paint finish. For indoor/outdoor installation
  • Max torque – hollow studs M12 - 10 Nm
  • Max torque - earth connection M10 - 7 Nm
     
 
Shandor Ltd., 4002 Plovdiv, Bulgaria, e-mail: shandor(at)gbg.bg,   tel.: +359 898 528828, fax: +359 32 644878